通讯地址:山东聊城经济开发区华山路南首30号
固定电话:0635-8888299
传真号码:0635-8888109
移动电话:13287501888
联系人:陈经理
电子邮箱:1262980066@qq.com
网站编辑:南宁华盈非晶合金变压器有限公司 │ 发表时间:2018-10-26
南宁干式变压器">南宁干式变压器接线与接排工序的检查
Inspection of connection and connection process of high and low voltage switchgear in Guizhou
关于南宁干式变压器质量的检查主要分为两方面内容,一方面是南宁干式变压器接线工序的检查,还有一方面则是南宁干式变压器接排工序的检查。若是各方面都满足要求的话,说明南宁干式变压器的质量
The inspection of the quality of the high and low voltage switchgear is mainly divided into two parts. One is the inspection of the wiring procedure of the high and low voltage switchgear, and the other is the inspection of the switchgear connecting process. If all aspects are satisfied, the quality of the high and low voltage switchgear
是合格的。
It is qualified.
南宁干式变压器浅谈首先进行的是南宁干式变压器接线工序的检查,先是检查其导线是否连接牢靠,要求每个端子只允许连接一根导线,必要时允许连两条导线;同时穿越金属构件的绝缘导线应有
The switch cabinet in Guizhou is discussed in the first place. The first is to check the wiring process of the high and low voltage switchgear. First it is to check whether the conductor is reliable and connected. It requires that each terminal only allow one conductor to co干式变压器厂nnect, if necessary, allow two wires to be connected. Meanwhile, the insulated conductor passing through the metal component should have a proper connection.
保护导线不受损伤的措施。
Measures to protect the wire from damage.
再要干式变压器厂用线束布线,线束要横平竖直,且横向不大于30mm,竖向不大于400mm,应有一个固定点;若是交流回路的导线穿越金属隔板时,该电路所有相线和零线均应从同一孔中穿过。
The wiring harness should be wiring again. The wiring harness must be horizontal and vertical, and the transverse length is not greater than 30mm, and the vertical is not greater than 400mm. There should be a fixed point. If the conductor of the AC circuit passes through the metal diaphragm, all phases and zeros of the circuit should be passed through the same hole.
然后是南宁干式变压器接排工序检查,重点是在母排加工质量及其安装质量的检查,母排表面涂层无流痕、应均匀,母排弯曲处不得有裂纹及大于1mm的皱纹,表面应无起皮、锤痕、凹坑、毛
Then the high and low voltage switch cabwww.tv2018.cominet discharging process inspection, the focus is on the bus process quality and check installation quality, no flow marks, busbar surface coating should be uniform, bending at the bus there shall be no crack and more than 1mm of the surface should be no wrinkles, skin, hair, hammer marks, pits
刺等;南宁干式变压器小编今天就分享到这里了。
The Guizhou switch cabinet is shared here today.
Copyright © 2017 南宁非晶合金变压器_南宁干式变压器_华盈非晶合金变压器有限公司 技术支持:互联纵横
<meta name="wlhlauth" content="26b08b3170bb57da2daa8fd2903c5785"/>